Dell PowerEdge R610 Hardware Owner's Manual page 40

Table 1-2. System Messages (continued)
Message
BIOS Update
Attempt Failed!
Caution!
NVRAM_CLR jumper
is installed on
system board
CPU set to
minimum
frequency.
CPU x installed
with no memory.
40
About Your System
Causes
Remote BIOS update
attempt failed.
NVRAM_CLR jumper is
installed in the clear setting.
CMOS has been cleared.
The processor speed may be
intentionally set lower for
power conservation.
Memory modules are
required but not installed in
the indicated processor's
memory slots.
Corrective Actions
Retry the BIOS update. If
the problem persists, see
"Getting Help."
Move the NVRAM_CLR
jumper to the default
position (pins 3 and 5). See
"System Board Connectors"
for jumper location.
After restoring the jumper,
update the desired settings in
the BIOS System Setup
program. See "Using the
System Setup Program and
UEFI Boot Manager."
If not an intentional setting,
check any other system
messages for possible causes.
Install memory modules for
the processor. See "System
Memory."