Dell PowerEdge R610 Hardware Owner's Manual page 26

Table 1-1. LCD Status Messages (continued)
Code Text
E1311 Fan module ##
RPM exceeding
range. Check
fan.
E1313 Fan
redundancy
lost. Check
fans.
E1410 System Fatal
Error
detected.
E1414 CPU # temp
exceeding
range. Check
CPU heatsink.
E1418 CPU # not
detected.
Check CPU is
seated
properly.
E141C Unsupported
CPU
configuration
Check CPU or
BIOS
revision.
26
About Your System
Cause
RPM of specified fan in
specified module is outside
of intended operating
range.
The system is no longer fan
redundant. Another fan
failure would put the
system at risk of over-
heating.
A fatal system error has
been detected.
Specified processor is out of
acceptable temperature
range.
Specified processor is
missing or bad, and the
system is in an unsupported
configuration.
Processors are in an
unsupported configuration.
Corrective Actions
See "Troubleshooting
System Cooling
Problems."
Check LCD for additional
scrolling messages. See
"Troubleshooting a Fan."
Check LCD for additional
scrolling messages.
Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Getting Help."
Ensure that the processor
heat sinks are properly
installed. See
"Troubleshooting the
Processors" and
"Troubleshooting System
Cooling Problems."
Ensure that the specified
microprocessor is properly
installed. See
"Troubleshooting the
Processors."
Ensure that your
microprocessors match
and conform to the type
described in the
microprocessor technical
specifications outlined in
your system's Getting
Started Guide.