LOGICDATA CBIsolid Series Operating Manual page 20

CBISOLID FAMILY OPERATING MANUAL // PAGE 20
8 ADDITIONAL INFORMATION
This section contains specific functions when using CBIsolid family handsets. A full list of Software-
Dependent Functions can be found in the Operating Manual of the installed Control Box.
8.1 FACTORY RESET (S0 RESET)
With this function you can reset the Control Box to its factory settings.
8.1.1 USING CBIsolid B AND D HANDSETS
1. Disconnect the Control Box from the mains.
2. While disconnected, press and hold the UP Key
3. Reconnect the Control Box. Hold the Key until the Control Box clicks twice per
second (CBIsolid B) or a decimal unit on a display starts to blink (CBIsolid D).
4. Release the UP Key
▸ The Control Box has now been reset to its factory settings. It is now the same
state as it was during the first start-up.
8.1.2 USING CBIsolid C HANDSET
1. Press and hold the following Keys for 3 seconds:
▸ Memory Position Keys 1 and 2
1 2
▸ UP Key
S 4
▸ The display shows S and a number (e.g. S4)
2. Press the DOWN Key until the display shows S 0
S 0
▸ The display shows S 0
M
3. Press the Memory Save Key
▸ The Control Box has now been reset to its factory settings. It is now the same
state as it was during the first start-up.