LOGICDATA CBIsolid Series Operating Manual page 15

CBISOLID FAMILY OPERATING MANUAL // PAGE 15
6 ASSEMBLY
This chapter describes the process of installing the CBIsolid Family Handset into the Height-Adjustable
Table System.
6.1 SAFETY DURING ASSEMBLY
The following safety instructions are valid for each Handset within the CBIsolid Family. Hazards relating
only to the installation of a specific Handset are listed in that Handset's assembly instructions.
CAUTION Risk of minor or moderate injury through improper handling
Improper handling of the product during assembly may lead to minor or moderate
injury through cutting, pinching, and crushing.
• Avoid contact with sharp edges
• Be careful while handling tools that may cause personal injury
• Ensure assembly complies with the generally accepted standards and guidelines of
electrical engineering and furniture manufacturing
• Read all instructions and safety advice carefully
CAUTION Risk of minor or moderate injury through tripping
During assembly and operation, poorly routed Cables may become a trip hazard.
Tripping over Cables may lead to minor or moderate injury.
• Ensure that Cables are routed properly to avoid trip hazards
• Be careful not to trip over Cables when installing the Handset
NOTICE
Ensure proper ESD handling during assembly. Damage that can be attributed to
electrostatic discharge will void warranty claims.
NOTICE
To avoid damage to the product, measure the dimensions of the Handset before assembly.
NOTICE
Before assembly, all parts must be acclimatised to the ambient conditions.
NOTICE
Do not lift the Handset by its cable. This will cause irreparable damage to the product.
INFO
Perform a product risk assessment so that you can respond to potential residual
hazards. Assembly instructions must be included in your end user Operating Manual.