Zendure SolarFlow Smart PV Hub User Manual page 6

Disposal
Disposal of packaging. Dispose of the packaging separately by type.
Dispose of cardboard and paper in the waste paper collection. Foils
for recycling collection.
Dispose of old equipment (applies in the European Union and other
European countries with separate collection (waste collection))
Old equipment must not be disposed of in household waste! Every
consumer is legally obliged to dispose of old equipment that can no
longer be used separately from household waste, for example at a
collection point for recyclables.
To ensure proper recycling and avoid negative impact on the
environment, electronic devices must be taken to a collection point
in their community or district. For this reason, electronic devices are
marked with the symbol shown here.
Batteries and accumulators must not be disposed of in household
waste! As a consumer, you are legally obliged to dispose of all
batteries and accumulators, regardless of whether they contain
pollutants or not, at a designated collection point.To be delivered to
the collection point in your community/city or to the trade, so that
they can be disposed of in an environmentally friendly way.
Marked with: Cd = Cadmium, Hg = Mercury, Pb = Lead. Return your
product with built-in battery only in a discharged state to your
collection point!
4. Important Tips
The solar PV system is grid-tied. Please check if it is allowed in your
√
area. Depending on the region,of ficial approval may be required
√
√
√
before or after installation.
√
Smart PV Hub and AB1000 should be protected from direct sunlight
to prevent rapid temperature increase.
Please check the accessories before installation, some accessories
€ need to be purchased separately.
After the installation, please first download the Zendure App to
check electricity produced and set the power to the Microinverter.
After SolarFlow installation, it will take about 5 minutes before it can
be connected to the grid, and the data will be synchronized to the
Zendure App within 20 minutes.
Before setting the output to Microinverter, please confirm the rated
power of your Microinverter, the output to Microinverter should not
!
be greater than the rated power of your Microinverter.
Please turn off the device（press and hold the IoT button on Smart
PV Hub for 6 seconds ) for removing or installing battery AB1000.
EN
6