ST STM32WB07 Manual page 7

6 Quick start
This section describes how to start development quickly using NUCLEO-WB07CC.
To use the product, you must accept the evaluation product license agreement from the
webpage.
Before the first use, make sure that no damage occurred to the board during shipment:
• All socket components must be firmly secured in their sockets.
• Nothing must be loose in the board blister.
The Nucleo board is an easy-to-use development kit to evaluate quickly and start development with an STM32
microcontroller in a VFQFPN48 package.
6.1 Getting started
Follow the sequence below to configure the STM32WB07CC board and launch the demonstration application
(refer to Figure 3
1. Check the jumper positions: JP2 ON, JP1 on USB_STLK [1-2] on the MB1801 board.
2. Check that switch SW1 is on the 3V3 power supply (switch on position [1-2]) on the MB1801 board.
3. Install ST Bluetooth
device from the App Store or Google Play.
4. Connect the Nucleo board to a PC with a USB cable Type-A or USB Type-C
ST-LINK USB connector (CN15). The green LEDs LD4 (5 V) and LD5 (ST-LINK power status), and the red
LED (LD6, ST-LINK COM status) light up. For more information about ST-LINK PWR and COM LEDs, refer to
the technical note Overview of ST-LINK derivatives (TN1235).
5. Use ST Bluetooth
and connect it. The smartphone application displays the service and characteristics of the device.
6. Pushing the button (B1) on the board toggles the alarm on the smartphone display. On the smartphone, push
the lamp to switch ON/OFF the Nucleo board blue LED (LD1).
UM3344 - Rev 1
and Figure 5 for component location):
®
Low Energy sensor mobile application on a Bluetooth
®
Low Energy sensor mobile application to detect the STM32WB07 P2P server (P2PSRV)
UM3344
Quick start
www.st.com/epla
®
Low Energy compatible mobile
® ®
to USB Type-C through the
page 7/51