Instructions For Use; Preliminary Checking Operations - APRILIA SCARABEO 125 - 2003 Manual

INSTRUCTIONS FOR USE

WARNING
Before departure, always carry out a
preliminary checking of the vehicle, to
make sure that it functions correctly
and safely, see the following table
( P R E L I M I N A R Y
OPERATIONS).
Failure to perform these checks can
cause severe personal injuries or
damage to the vehicle.
Do not hesitate to consult your aprilia
O f f i c i a l D e a l e r i n c a s e t h e r e i s
something you do not understand
about the operation of some controls or
in case you suspect or discover some
irregularities.
It does not take long to carry out a
check-up and this operation ensures
you much more safety.
30
use and maintenance Scarabeo 125 - Scarabeo 200

PRELIMINARY CHECKING OPERATIONS

Component
Front and rear
disc brakes
C H E C K I N G
Brake levers
Throttle
Wheel/tyres
Steering
Side stand and centre
stand
Fastening elements
Fuel tank
Coolant
Engine stop switch
( - )
Lights, warning lights,
h o r n a n d e l e c t r i c a l
devices
Check
Check the functioning, the idle stroke of the control levers, the
fluid level and make sure there are no leaks.
Check the wear of the pads and noise reducing plates (at the
rear only). If necessary, top up the brake reservoir.
Make sure that they work smoothly.
If necessary, lubricate the joints.
Make sure that it works smoothly and that it is possible to
open and close it completely, in all steering positions. If
necessary, adjust and/or lubricate it.
Check the tyre surface, the inflation pressure, wear and tear
and any damage.
Make sure that the steering rotates smoothly, without any
clearance or slackening.
Make sure that they work smoothly and that the spring
tension brings them back to their normal position.
If necessary, lubricate joints and hinges.
Make sure that the fastening elements are not loose.
If necessary, adjust or tighten them.
Check the fuel level and top up, if necessary.
Make sure there are no leaks or obstacles in the circuit. Make
sure the filler cap is correctly tightened.
The coolant level in the expansion tank must be included
between the "MIN" and "MAX" marks.
Make sure that it operates correctly.
Check the proper operation of the acoustic and visual
devices.
Change the bulbs or carry out the necessary repairs in case
of failure.
Page
24, 43
-
51
28
46
44
-
22, 61
26, 27
17
53-60