Vertical Adjusting Of The Headlight Beam; 125, 150 Horizontal Adjustment Of The Headlight Beam Usa - APRILIA LEONARDO 125 - 1999 Manual

To rapidly check the correct direction of the
beam, place the vehicle on flat ground, 10
m away from a wall.
Turn on the low beam, sit on the vehicle
and make sure that the beam projected on
the wall is slightly under the horizontal line
of the headlight (about 9/10th of the total
height).
To adjust the headlight beam:
Turn the appropriate screw (1) with a
screwdriver.
By TURNING IT CLOCKWISE, you set
the beam upwards.
By TURNING IT ANTICLOCKWISE, you
set the beam downwards.
Remove the front inner shield, see p. 52
( R E M O V I N G T H E F R O N T I N N E R
SHIELD).
Unscrew and remove the two screws
(2).
NOTE
Depending on the adjustment to
be carried out, the screws (2) must be re-
placed with longer ones (supplied in kit).
Position the appropriate spacers (sup-
plied in kit) between the headlight fasten-
ing points and the front outer shield, ac-
cording to the type of adjustment to be
carried out.
NOTE
Use fastening screws suitable for
the selected spacers.
Insert and tighten the two screws (2).
use and maintenance Leonardo 125 - Leonardo 150 - Leonardo 250
59