Controls On The Right Side Of The Handlebar - APRILIA LEONARDO 125 - 1999 Manual

NOTE
The electrical parts work only when the ignition switch is
in position " ".
o p
1) LIGHT SWITCH ( -
CAUTION
Before operating the light switch, make sure that the dim-
mer switch ( - ) is in position "
When the light switch is in position "
the switch is in position "
board light are on; when the switch is in position "
parking lights, the dashboard light and the low beam are on.
The high beam can be operated by means of the dimmer
switch ( - ).
1a) DIMMER SWITCH (
( not provided for those countries where the engine
stop switch " - " is required)
When it is in position "
light and the low beam are always on.
When it is in position "
1b) ENGINE STOP SWITCH (
(in the countries where required)
Do not operate the engine stop switch "
conditions.
This is a safety or emergency switch. With the switch in po-
sition " ", it is possible to start the engine; the engine can
be stopped by moving the switch to position " ".
•
- ) ( not provided)
".
•
", the lights are off; when
", the parking lights and the dash-
- )
" the parking lights, the dashboard
", the high beam comes on.
- )
WARNING
- " in running
", the
With stopped engine and ignition switch in position " ",
the battery may run down.
When the vehicle has come to a halt, stop the engine, and
move the ignition switch to position " ".
2) START PUSH BUTTON (
When the start push button " " is pressed, the starter makes
the engine run. For the starting, see p. 33 (STARTING).
use and maintenance Leonardo 125 - Leonardo 150 - Leonardo 250
CAUTION
)
19