Quantum DAT 72/DDS-4 User Manual page 25

2
Setting the SCSI ID
Parameter
Power On Self Test (POST) Diagnostics
Host Operating System
SCSI Termination Power
Parity Checking
If these default settings are appropriate for your computer, skip to
Connecting the SCSI Interface
These settings can be changed by accessing the switches
Note:
located on the bottom of the autoloader. Turn the autoloader
over and gently pull the tab on the access door to release it.
Once the door is open, the switches will be accessible.
Make sure that the autoloader is turned off; then set the SCSI ID using the
push-button switch on the back of the autoloader. The following figure
shows this switch, as well as the two SCSI interface connectors, on/off
switch, and the power cord connector.
Note: The autoloader must be restarted for any change in SCSI ID to
take effect.
DAT 72/DDS-4 6-Slot Autoloader User's Guide
Chapter 2 Installing the Autoloaders
Installing the Desktop Autoloader
Default Setting
ME/NT 4.0/2000/
XP/Windows Server
Cable..
Enabled
Windows 98 SE/
2003
Disabled
Enabled
9