The Static Dhcp Screen; The Ppp Interfaces - ZyXEL Communications ZYWALL USG 2000 Manual

Unified security gateway

Hide thumbs Also See for ZYWALL USG 2000:

Table of Contents

Chapter 10 Interface

10.5 The Static DHCP Screen

In an interface add or edit screen, click Edit static DHCP table to open the

Static DHCP screen. Use this screen to configure the list of static IP addresses

the ZyWALL assigns to computers connected to the interface. If a computer's MAC

address is in the interface's static DHCP table, the ZyWALL assigns the

corresponding IP address. Otherwise, the ZyWALL assigns an IP address

dynamically using the interface's IP Pool Start Address and Pool Size.

You must click OK in the Static DHCP screen and then click OK in the interface

add or edit screen to save your changes.

Figure 132 Static DHCP

The following table describes this screen.

Table 51 Static DHCP

This section introduces PPPoE, PPTP, and PPPoE/PPTP interfaces and then explains

the screens for PPPoE/PPTP interfaces.

This field is a sequential value, and it is not associated with a specific

Enter the IP address to assign to a device with this entry's MAC

Enter the MAC address to which to assign this entry's IP address.

Enter a description to help identify this static DHCP entry. You can use

alphanumeric and ()+/:=?!*#@$_%- characters, and it can be up to

60 characters long.

This column lets you create and remove static DHCP entries.

To add an entry, click the Add icon.

To remove an entry, click it's Remove icon.

Click OK to save your changes back to the ZyWALL.

Click Cancel to exit this screen without saving.

ZyWALL USG 2000 User's Guide