ZyXEL Communications ZYWALL USG 2000 Manual page 207

Note: The WAN IP addresses of a ZyWALL with multiple WAN interfaces must be on
different subnets.
Figure 136 Network > Interface > Cellular
The following table describes the labels in this screen.
Table 55 Network > Interface > Cellular
LABEL
#
Name
Extension Slot
Connected
Device
ISP Settings
Add icon
Apply
Reset
ZyWALL USG 2000 User's Guide
DESCRIPTION
This field is a sequential value, and it is not associated with any
interface.
This field displays the name of the interface.
This field displays where the entry's cellular card is located.
This field displays the name of the cellular card.
This field displays the profile of ISP settings that this cellular interface is
set to use.
This column lets you create, edit, remove, activate, and deactivate
cellular interfaces.
To create an interface, click the Add icon at the top of the column. In
the pop-up window that displays, select the slot that you want to
configure.
To activate or deactivate an interface, click the Active icon next to it.
Make sure you click Apply to save and apply the change.
To edit an interface, click the Edit icon next to it. The edit screen
appears.
To remove an interface, click the Remove icon next to it. The ZyWALL
confirms you want to remove it before doing so.
To connect or disconnect an interface, click the Connect icon next to it.
You might use this icon to test the interface or to manually establish the
connection.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
Chapter 10 Interface
207