ZyXEL Communications ZYWALL USG 2000 Manual page 152

Chapter 7 Status
Table 31 Status (continued)
LABEL
HA Status
Zone
IP Address
Action
Extension Slot
Slot
Device
Status
System Status
System Uptime This field displays how long the ZyWALL has been running since it last
Current Date/
Time
VPN Status
DHCP Table
Port Statistics
Current Login
User
152
DESCRIPTION
This field displays the status of the interface in the virtual router.
Active - This interface is the master interface in the virtual router.
Stand-By - This interface is a backup interface in the virtual router.
Fault - This VRRP group is not functioning in the virtual router right now.
For example, this might happen if the interface is down.
n/a - Device HA is not active on the interface.
This field displays the zone to which the interface is currently assigned.
This field displays the current IP address assigned to the interface. If the
IP address is 0.0.0.0, the interface is disabled or did not receive an IP
address and subnet mask via DHCP.
If this interface is a member of an active virtual router, this field displays
the IP address it is currently using. This is either the static IP address of
the interface (if it is the master) or the management IP address (if it is a
backup).
Use this field to get or to update the IP address for the interface.
Click Renew to send a new DHCP request to a DHCP server.
Click the Connect icon to have the ZyWALL try to connect a PPPoE/PPTP
interface or the auxiliary interface. If the interface cannot use one of
these ways to get or to update its IP address, this field displays n/a.
Click the Disconnect icon to stop a PPPoE/PPTP or auxiliary interface's
connection.
This section of the screen displays the status of the extension card slot
and the USB ports.
This field displays the name of each extension slot.
This field displays the name of the device connected to the extension slot
(or none if no device is detected).
For installed SEM (Security Extension Module) cards, this field displays a
Detail icon that you can click to see detailed card status information.
restarted or was turned on.
This field displays the current date and time in the ZyWALL. The format
is yyyy-mm-dd hh:mm:ss.
Click this to look at the VPN tunnels that are currently established. See
Section 7.2.4 on page 158.
Click this to look at the IP addresses currently assigned to the ZyWALL's
DHCP clients and the IP addresses reserved for specific MAC addresses.
See Section 7.2.5 on page
Click this to look at packet statistics for each Gigabit Ethernet port. See
Section 7.2.6 on page 160.
This field displays the user name used to log in to the current session,
the amount of reauthentication time remaining, and the amount of lease
time remaining. See Chapter 36 on page
159.
613.
ZyWALL USG 2000 User's Guide