Configuring Active Directory Or Ldap Default Server Settings - ZyXEL Communications ZYWALL USG 2000 Manual

40.2.1 Configuring Active Directory or LDAP Default Server
Settings
To configure the Active Directory or LDAP default server settings, click Object >
AAA Server > Active Directory (or LDAP) to display the screen as shown.
Figure 428 Object > AAA Server > Active Directory (or LDAP) > Default
The following table describes the labels in this screen.
Table 202 Object > AAA Server > Active Directory (or LDAP) > Default
LABEL
Host
Port
Bind DN
Password
Base DN
CN Identifier
Search time
limit
ZyWALL USG 2000 User's Guide
DESCRIPTION
Enter the IP address (in dotted decimal notation) or the fully-qualified
domain name (up to 63 alphanumerical characters) of an AD or LDAP
server.
Specify the port number on the AD or LDAP server to which the ZyWALL
sends authentication requests. Enter a number between 1 and 65535.
The default is 389.
Specify the bind DN for logging into the LDAP server. Enter up to 63
alphanumerical characters.
For example,
cn=zywallAdmin
name.
If required, enter the password (up to 15 alphanumerical characters)
for the ZyWALL to bind (or log in) to the AD or LDAP server.
Specify the directory (up to 63 alphanumerical characters). For
example,
o=ZyXEL, c=US
Specify the unique common name that uniquely identifies a record in
the AD or LDAP directory. Enter up to 63 alphanumerical characters.
Specify the timeout period (between 1 and 300 seconds) before the
ZyWALL disconnects from the AD or LDAP server. In this case, user
authentication fails.
The search timeout occurs when either the user information is not in the
LDAP server or the server is down.
Chapter 40 AAA Server
specifies
zywallAdmin
.
as the user
651