Configuring Bob's X550N Vpn Settings; Figure 45 Property; Figure 46 Local Policy - ZyXEL Communications X550N - V3.60 User Manual

Table 27 Site-To-Site VPN Tunnel Settings (continued)
SETTING
Local ID Type
Local Content
Secure Gateway
Address
Peer ID Type
Peer Content
Encapsulation
Mode
IPSec Protocol
Pre-Shared Key
Encryption
Algorithm
Authentication
Algorithm

6.2.1 Configuring Bob's X550N VPN Settings

To configure these settings Bob uses the X550N web configurator.
1 Log into the X550N web configurator and click VPN > Modify icon. This displays the
VPN Rule Setup (basic) screen.
2 Select the Active checkbox to enable the VPN rule after it has been created. Make sure
IKE is selected as the IPSec Keying Mode.

Figure 45 Property

3 Enter the IP address "192.168.1.35" in the Local Address text box. This is the IP
address of Bob's computer. Enter the IP address "192.168.1.35" in the Local Address
End/Mask text box. This value is the same as Bob only wants Jack to access this single
IP address.

Figure 46 Local Policy

4 Enter the IP address "10.0.0.7" in the Remote Address Start text box. This is the IP
address of Jack's computer. Enter the IP address "10.0.0.7" in the Remote Address
X550N Series User's Guide
BOB'S X550N
IP
1.1.1.1
2.2.2.2
IP
2.2.2.2
Tunnel
ESP
ThisIsMySecretKey
3DES
SHA1
Chapter 6 Tutorials
JACK'S X550N
IP
2.2.2.2
1.1.1.1
IP
1.1.1.1
Tunnel
ESP
ThisIsMySecretKey
3DES
SHA1
81