ZyXEL Communications X550N - V3.60 User Manual page 74

Chapter 6 Tutorials
6.1.2.1 Push Button Configuration (PBC)
1 Make sure that your X550N is turned on and that it is within range of your computer.
2 Make sure that you have installed the wireless client (this example uses the NWD210N)
driver and utility in your notebook.
3 In the wireless client utility, find the WPS settings. Enable WPS and press the WPS
button (Start or WPS button)
4 Log into X550N's web configurator and press the Push Button button in the Network >
Wireless Client > WPS Station screen.
Your X550N has a WPS button located on its panel, as well as a WPS button
in its configuration utility. Both buttons have exactly the same function; you can
use one or the other.
It doesn't matter which button is pressed first. You must press the second
button within two minutes of pressing the first one.
The X550N sends the proper configuration settings to the wireless client. This may take up to
two minutes. Then the wireless client is able to communicate with the X550N securely.
The following figure shows you an example to set up wireless network and security by
pressing a button on both X550N and wireless client (the NWD210N in this example).
74
X550N Series User's Guide