Configuring Advanced Setup; Table 58 Menu 2.1 Isdn Advanced Setup - ZyXEL Communications P-202H V2 User Manual

The following table describes the fields in this menu.

Table 58 Menu 2.1 ISDN Advanced Setup

FIELD
Phone 1/2 Call
Waiting
Calling Line
Indication
PABX Outside Line
Prefix
PABX Number
(Include S/T Bus
Number) for
Loopback
Outgoing Calling
Party Number
ISDN Data
A/B Adapter 1
A/B Adapter 2
Hangup Silence
Time(sec)
Data Link
Connection
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to Confirm..." to
save your configuration, or press [ESC] at any time to cancel.

17.2.2 Configuring Advanced Setup

When you are finished, press [ENTER] at the message: 'Press ENTER to confirm or ESC to
Cancel', the ZyXEL Device uses the information that you entered to initialize the ISDN line. It
should be noted that whenever the switch type is changed, the ISDN initialization takes
slightly longer.
At this point, the ZyXEL Device asks if you wish to test your ISDN. If you select Yes, the
ZyXEL Device will perform a loop-back test to check the ISDN line. If the loop-back test
fails, please note the error message that you receive and take the appropriate troubleshooting
action.
Chapter 17 Menu 2 ISDN Setup
DESCRIPTION
The Call Waiting feature on your ISDN line works in exactly the same way as it
does on a regular analog line. After hearing a call waiting indicator tone, press and
immediately release the flash button on your telephone. This puts your current call
on hold and answers the incoming call.
The Calling Line Indication, or Caller ID, governs whether the other party can see
your number when you call. If set to Enable, the ZyXEL Device sends the caller
ID and the party you call can see your number; if it is set to Disable, the caller ID is
blocked.
Enter the number for outside line access if the ZyXEL Device is connected to a
PABX; otherwise, leave it blank. The maximum number of digits is 4.
Enter the S/T bus number if the ZyXEL Device is connected to an ISDN PABX. If
this field is left as blank then the ISDN loopback test will be skipped.
You only need to fill in this field if your switch requires a specific Outgoing Calling
Party Number; otherwise, leave it blank.
Enter the telephone number(s) assigned to your ISDN line by your telephone
company. Some switch types only have one telephone number. Note that the
ZyXEL Device only accepts digits; please do not include '-' or spaces in this field.
This field should be no longer than 25 digits.
Enter the telephone number assigned to A/B Adapter 1 (PHONE1).
Enter the telephone number assigned to A/B Adapter 2 (PHONE2).
Most answering machines automatically terminate a call after a predefined length
of silence. Specify the time in seconds that elapses before the answering machine
drops the call when the ZyXEL Device receives tones from the switch and send a
silence tone to the answering machine.
There are two types of ISDN Data Link Connection namely: point-to-multipoint
and point-to-point. When you select point-to-multipoint, the TE1 value will be
assigned by negotiation with the switch. When you select point-to-point, the TE1
value will be assigned a unique value of 0.
P-202H Plus v2 User's Guide
174