Command Usage; Call Control Support; Figure 190 Valid Commands; Figure 191 Menu 24.9 System Maintenance : Call Control - ZyXEL Communications P-202H V2 User Manual

P-202H Plus v2 User's Guide

30.1.2 Command Usage

A list of commands can be found by typing help or ? at the command prompt. Always type
the full command. Type exit to return to the SMT main menu when finished.

Figure 190 Valid Commands

Copyright (c) 1994 - 2006 ZyXEL Communications Corp.
ras> ?
Valid commands are:
sys
config
ipsec
ras>

30.2 Call Control Support

The ZyXEL Device provides four call control functions: call control parameters, blacklist,
budget management and call history.
Call control parameters allows you to set a dial out time limit, the number of times a number
should be called before it is added to the blacklist and the interim between calls.
The budget management function allows you to set a limit on the total outgoing call time of
the ZyXEL Device over a period of time. When the total outgoing call time exceeds the limit,
the current call will be dropped and any future outgoing calls will be blocked.
The blacklist function prevents the ZyXEL Device from re-dialing to an unreachable phone
number. It is a list of phone numbers, up to a maximum of 14, to which the ZyXEL Device
will not make an outgoing call. If the ZyXEL Device tries to dial to a phone number and fails
a certain number of times (configurable in Menu 24.9.1), then the phone number is placed on
the blacklist. You will have to enable the number manually before the ZyXEL Device will dial
that number again.
Call history chronicles preceding incoming and outgoing calls.
To access the call control menu, select option 9 in menu 24 to go to Menu 24.9 - System
Maintenance - Call Control, as shown in the next table.

Figure 191 Menu 24.9 System Maintenance : Call Control

285
exit device
isdn radius
ppp hdap
Menu 24.9 - System Maintenance - Call Control
1. Call Control Parameters
2. Blacklist
3. Budget Management
4. Call History
Enter Menu Selection Number:
ether
ip
dcp
Chapter 30 System Maintenance