Ip Screen - ZyXEL Communications NWA-1100 Manual

Chapter 11 IP Screen

11.4 IP Screen

Use this screen to configure the IP address for your NWA. Click IP to display the following screen.
Figure 51 IP Setup
The following table describes the labels in this screen.
Table 33 IP Setup
LABEL
Obtain IP Address
Automatically
Use Fixed IP Address
IP Address
Subnet Mask
Gateway IP Address
Spanning Tree
Apply
Reset
106
DESCRIPTION
Select this option if your NWA is using a dynamically assigned IP address
from a DHCP server each time.
Note: You must know the IP address assigned to the NWA (by the DHCP
server) to access the NWA again.
Select this option if your NWA is using a static IP address. When you select
this option, fill in the fields below.
Enter the IP address of your NWA in dotted decimal notation.
Note: If you change the NWA's IP address, you must use the new IP address
if you want to access the web configurator again.
Type the subnet mask.
Type the IP address of the gateway. The gateway is an immediate neighbor
of your NWA that will forward the packet to the destination. On the LAN,
the gateway must be a router on the same segment as your NWA; over the
WAN, the gateway must be the IP address of one of the remote nodes.
(R)STP (Section 11.5.2 on page
provides backup links between switches, bridges or routers. It allows a
bridge to interact with other (R)STP -compliant bridges in your network to
ensure that only one path exists between any two stations on the network.
Select the check box to activate STP on the NWA.
Click Apply to save your changes.
Click Reset to begin configuring this screen afresh.
107) detects and breaks network loops and
NWA1100-N User's Guide