Wireless Client - ZyXEL Communications NWA-1100 Manual

Table 23 Security: 802.1x Only for Access Point (continued)
LABEL
Reset
Back

8.4.2.2 Wireless Client

Use this screen to use 802.1x-Only security mode for your NWA that is in Wireless Client operating
mode. Select 802.1x-Only in the Security Mode field to display the following screen.
Figure 38 Security: 802.1x Only for Wireless Client
The following table describes the labels in this screen.
Table 24 Security: 802.1x Only for Wireless Client
LABEL
Security Settings
Profile Name
Security Mode
Data Encryption
IEEE802.1x Authentication
EAP Type
User Information
Username
Password
Apply
Reset
Back
NWA1100-N User's Guide
DESCRIPTION
Click Reset to begin configuring this screen afresh.
Click Back to return to the previous screen.
DESCRIPTION
This is the name that identifying this profile.
Choose the same security mode used by the AP.
Select between None and Dynamic WEP. Refer to
information on using Dynamic WEP.
The options on the left refer to EAP methods. You can choose either TLS, LEAP,
PEAP or TTLS.
The options on the right refer to authentication protocols. You can choose
between MSCHAPv2 and GTC.
Supply the username of the account created in the RADIUS server.
Supply the password of the account created in the RADIUS server.
Click Apply to save your changes.
Click Reset to begin configuring this screen afresh.
Click Back to return to the previous screen.
Chapter 8 Wireless Security Screen
Appendix E on page 198 for
91