Using The Hard Disk; Installing The Hard Disk - Dell 2145cn User Manual

5. Holding the memory module by the edges, align the memory module on
the slot at about a 30-degree tilt. Ensure that the notches of the module
and the grooves on the slot fit each other.
The notches and grooves illustrated above may not match those
on an actual memory module and its slot.
6. Press the memory module into the slot with care until you hear a 'click'.
Do not press the memory module strongly or the module may be
damaged. If the module does not seem to fit into the slot properly,
carefully try the previous procedure again.
7. Replace the control board cover and fasten the cover with the screws.
8. Replace the rear cover and fasten the cover with the screw.
9. Reconnect the power cord and printer cable, and turn the printer on.
To release the memory module, pull the two tabs on the sides of
the slot outwards, then the module springs out.
10. If you use the PS driver, you must activate the added memory in the PS
driver properties.
See "Activating the added accessories in printer properties" on page 84.

USING THE HARD DISK

Installing the hard disk allows the data from your computer to be sent to the
print queue of the printer hard disk. This decreases the workload of the
computer. You can also use various print features, such as storing a job in
the hard disk, proofing a job, and printing private documents.

Installing the hard disk

For order information, see "Accessories" on page 83. Review the
precautions on page 84.
1. Turn the printer off and unplug all cables from the printer.
2. Release the screws and remove the rear cover.
3. Open the control board cover. Release the screws, then lift up the cover
slightly and pull the cover to the right.
4. Align the connector on the hard disk with the connector on the control
board. Push the hard disk in until it is latched into place
.
1 control board
cover
Installing accessories 85
|