Dell 2145cn User Manual page 76

CONDITION SUGGESTED SOLUTIONS
Color or Black If the amount of background shading becomes
unacceptable:
background
• Change to a lighter weight paper. See
"Selecting print media" on page 24.
• Check the printer's environment: very dry
(low humidity) or high humidity (higher than
80% RH) conditions can increase the
amount of background shading.
• Remove the old toner cartridge and install
a new one. See "Replacing the toner
cartridge" on page 59.
Toner smear • Clean the inside of the printer. See
"Cleaning the inside" on page 56.
• Check the paper type and quality. See
"Selecting print media" on page 24.
• Remove the toner cartridge and install a
new one. See "Replacing the toner
cartridge" on page 59.
Vertical repetitive If marks repeatedly appear on the printed side
of the page at even intervals:
defects
• The toner cartridge may be damaged. If a
repetitive mark occurs on the page, print a
cleaning sheet several times to clean the
cartridge. After the printout, if you still have
the same problems, remove the toner
cartridge and install a new one. See
"Replacing the toner cartridge" on page 59.
• Parts of the printer may have toner on
them. If the defects occur on the back of
the page, the problem will likely correct
itself after a few more pages.
• The fusing assembly may be damaged.
Contact a service representative.
Background scatter Background scatter results from bits of toner
randomly distributed on the printed page.
• The paper may be too damp. Try printing
with a different batch of paper. Do not open
A
packages of paper until necessary so that
the paper does not absorb too much
moisture.
• If background scatter occurs on an
envelope, change the printing layout to
avoid printing over areas that have
overlapping seams on the reverse side.
Printing on seams can cause problems.
• If background scatter covers the entire
surface area of a printed page, adjust the
print resolution through your software
application or the printer properties.
76 Troubleshooting
|
CONDITION SUGGESTED SOLUTIONS
Misformed • If characters are improperly formed and
characters producing hollow images, the paper stock
may be too slick. Try a different paper. See
"Selecting print media" on page 24.
• If characters are improperly formed and
producing a wavy effect, the scanner unit
may need service. For service, contact a
service representative.
Page skew • Ensure that the paper is loaded properly.
• Check the paper type and quality. See
"Selecting print media" on page 24.
• Ensure that the paper or other material is
loaded correctly and the guides are not too
tight or too loose against the paper stack.
Curl or wave • Ensure that the paper is loaded properly.
• Check the paper type and quality. Both high
temperature and humidity can cause paper
curl. See "Selecting print media" on
page 24.
• Turn over the stack of paper in the tray. Also
try rotating the paper 180° in the tray.
Wrinkles or creases • Ensure that the paper is loaded properly.
• Check the paper type and quality. See
"Selecting print media" on page 24.
• Turn over the stack of paper in the tray. Also
try rotating the paper 180° in the tray.
Back of printouts • Check for leaking toner. Clean the inside of
are dirty the printer. See "Cleaning the inside" on
page 56.