Invacare LiNX DLX-ACU200 User Manual page 17

For Primary Modules with Touch Displays:
1. Press the button once to power up.
2. Within 10 sec after power up, tap and hold lock screen. A white
square begins to show on screen.
3. Release hold only after white square has closed completely. T he
system is unlocked.
To unlock the system, an unlock sequence must be performed
by t he user within a specific time frame. If the sequence is not
performed c orrectly, within the time frame, the system will
remain locked and t he system will power down again.
For Primary Modules with Physical Horn Buttons (e.g. REM2xx):
1. Press the button.
2. Press the button twice. The system is unlocked.
The horn button must be pressed twice within 10 seconds after
pressing t he power button.
1608055-E
3.6 Reading the Indicators
3.6.1 Attendant-in-charge Indication (Attendant
Control Unit)
Attendant-in-charge indication Attendant-not-in-charge indication
The attendant-in-charge indication displays which remote module,
attendant control unit or primary remote module, has control of the
power wheelchair.
If the attendant control unit takes over control of the system, or
powers up with the attendant in charge, the power button and mode
button LEDs, drive function indicator, attendant indicator and the
selected function on the attendant control unit switch on immediately,
depending on the system status. If the primary remote has control of
the system, all LEDs are switched off on the attendant control unit.
3.6.2 User-in-Charge Indication (Compact Remote Module)
User-in-charge indication
The user-in-charge indication displays which remote module, compact
remote module or primary remote module, has control of the power
wheelchair.
3 Usage
User-not-in-charge indication
17