Invacare LiNX DLX-ACU200 User Manual page 15

If the remote that you want to perform an emergency stop on is not
remote-in-charge, you must request control / to be in-charge of the
power wheelchair first, refer to 3.1 Requesting Control of Power
Wheelchair, page 13.
If the remote-in-charge has been restricted, the power
wheelchair does not perform an emergency stop.
Using Lock Function
Lock function prevents unintentional use of the system when the
system is temporarily not required, refer to 3.5 Lock Mode, page 16.
Disabling Connectivity System-wide
This chapter applies only for compact remote modules DLX-
CR400 and DLX-CR400LF.
Connectivity gives access to more profiles. Connectivity can be
disabled.
1. Press and hold button for three seconds during
powering up.
The connectivity indicator and status LED pulse slowly
for five seconds, then connectivity indicator LED
switches off.
Interrupting or Waking up from Sleep
Before the system goes to sleep there is a transition period during
which you can interrupt the system from going to sleep.
1. Press the button.
Or:
2. Move the joystick.
1608055-E
3.4 Mode Button
B
Mode button on
attendant control unit
The Mode button B is on the right-hand side of the remote module
and contains a status LED that lights up, flashes or pulses depending
on the status of the system:
Lit together with all other LEDs on display — system powering up
l
or remote has become remote-in-charge, refer to 3.6.1
Attendant-in-charge Indication (Attendant Control Unit), page 17
or 3.6.2 User-in-Charge Indication (Compact Remote Module),
page 17.
Flashing 3x — remote locked, refer to 3.5 Lock Mode, page 16.
l
Lit while all other indicators are switched off — firmware
l
upgrade mode.
You can use the mode button for:
On attendant control unit:
l
Selecting attendant drive / seating functions within the
n
attendant profile
On compact remote module:
l
Selecting the drive/seating function within a profile (short
n
press)
Selecting the profile (long press)
n
3 Usage
B
Mode button on
compact remote
15