Changing The Console Resolution; Overview - Tech Source RAPTOR 1000 - OPENWINDOWS FOR SOLARIS INSTALLATION-REFERENCE Installation And Reference Manual

CHANGING THE CONSOLE
A.1 Overview
Normally the default console resolution is sufficient for most
users but if the monitor does not "sync-up" you may need to
change the console resolution.
NOTE: It is recommended that you use raptorconfig to
test a resolution before configuring the console to that
resolution.
The Raptor card can be configured to be the console in the
UltraSPARC workstation. Every Raptor card type has its own
default console resolution and default depth as shown in the
following table:
Board Resolution
Raptor
1000 1280x1024
Raptor
1100T 1280x1024
Raptor
2000 2048x2048
Raptor
2100T 2048x2048
Raptor
2500 2560x2048
Raptor 2560x2048 or
2500T 2048x2048
Raptor 2560x2048 or
2500T-DL 2048x2048
Appendix A
RESOLUTION
Refresh Bits/Pixels
67Hz 8
67Hz 8
60Hz 8
60Hz 8
60Hz 8
60Hz 8
60Hz 8
A-1
Sync
Separate
Separate
Separate
Separate
Separate
Seperate
Seperate