Other Pci Framebuffers - Tech Source RAPTOR 1000 - OPENWINDOWS FOR SOLARIS INSTALLATION-REFERENCE Installation And Reference Manual

Raptor OpenWindows for Solaris Installation and Reference Manual
Once the system is reset, all console messages will be directed
to the selected Raptor card.
NOTE: To restore the default graphics device as the console
for any reason, simply set the output-device variable back to its
default value of screen as below:
ok setenv output-device screen
ok reset-all

4.6.2.1 Other PCI Framebuffers

To make the Raptor card the console device when other PCI
framebuffers are present in the system, it may be necessary to
change the pcia-probe-list to probe the Raptor's slot before
that of the other framebuffers (in addition to making the changes
in 4.6.1, if applicable).
Determine the slot
framebuffers, then ensure that the Raptor slot number precedes
them in the pcia-probe-list.
For example, if the Raptor is located in slot 3, and a secondary
framebuffer is located in slot 1, then update the pcia-probe-
list so that slot 3 is probed BEFORE slot 1.
configuration may resemble the following:
ok setenv pcia-probe-list 3,2,1,4
ok reset-all
Once the system is reset, all console messages will be directed
to the Raptor card.
numbers that correspond
4-10
to these
A possible