Ultra 5 And Ultra 10 - Tech Source RAPTOR 1000 - OPENWINDOWS FOR SOLARIS INSTALLATION-REFERENCE Installation And Reference Manual

For solaris
Table of Contents

Advertisement

Chapter 3 – Software Installation for I-Class Cards
2.
Type the l e tter that corresponds to the Raptor card that
you want to use as the console device. Raptor cards can
be identified by looking for the string TSI or raptor in the
list of device names.
3.
Type setenv output-device <Control-Y>. When
you type <Control-Y>, the display that was selected in
the previous step will be inserted in the command line.
4.
Power off the system
5.
Connect your monitor cable to the onboard VGA connector
on your system back panel
Power on the system.
6.
3.5.1.2

Ultra 5 and Ultra 10

To use the Raptor as the system console on an Ultra 5 or Ultra
10 as the only framebuffer, first disable the graphics device
which comes built-in to the Ultra 5 and Ultra 10.
At the ok prompt, type:
ok setenv pcib-probe-list 1,3
ok reset-all
Once the system is reset, all console messages will be directed
to the Raptor card.
NOTE: To restore the motherboard's graphics device as the
console for any reason, simply add it back to the pcib-
probe-list as below:
ok setenv pcib-probe-list 1,2,3
ok reset-all
3-7

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RAPTOR 1000 - OPENWINDOWS FOR SOLARIS INSTALLATION-REFERENCE and is the answer not in the manual?

Table of Contents