Raptor As The Only Framebuffer; Sun Blade 100 And Sun Blade 150 - Tech Source RAPTOR 1000 - OPENWINDOWS FOR SOLARIS INSTALLATION-REFERENCE Installation And Reference Manual

Raptor OpenWindows for Solaris Installation and Reference Manual
't'
's'
'h'
'q'
3.5 Setting
(Optional)
This section describes how to configure the Raptor as the
console device in your system. For information on setting the
resolution in console mode, please refer to Appendix A.

3.5.1 Raptor as the Only Framebuffer

NOTE: If the procedure for your system is not described
below, please contact Tech Source.

3.5.1.1 Sun Blade 100 and Sun Blade 150

To use the Raptor as the system console on a Sun Blade 100 or
Sun Blade 150 use the following procedure:
1. At the ok prompt, type: show-displays. This will list the
installed graphics devices and a prompt to enter a
selection.
puts a test pattern on the entire
display (hit any key to return to
the main screen)
saves current settings and exits
help
exits the program without saving
any changes
Raptor as the
3-6
Console