Changing Resolution And Bit Depth; Raptor 1100T; Raptor 2100T; Raptor 2500T And Raptor 2500T-Dl - Tech Source RAPTOR 1000 - OPENWINDOWS FOR SOLARIS INSTALLATION-REFERENCE Installation And Reference Manual

For solaris
Table of Contents

Advertisement

Raptor OpenWindows for Solaris Installation and Reference Manual
4.4
Changing Resolution and Bit-Depths

4.4.1 Raptor 1100T

The default resolution of the Raptor 1100T is set to 1280x1024.
The resolution of this card can be changed through the
trzconfig utility. This utility can also be used to change the
bit-depths. Refer to Section 4.5 for details on using trzconfig.

4.4.2 Raptor 2100T

The resolution of the Raptor 2100T is fixed at 2048x2048.
However, the bit-depth can be changed.
depth, use the trzconfig utility.
details.

4.4.3 Raptor 2500T and Raptor 2500T-DL

The Raptor 2500T and Raptor 2500T-DL are configured in
hardware to support either 2048x2048 or 2560x2048 resolutions.
Therefore, depending on your flat panel subsystem, it will
support the appropriate resolution. For example, Raptor 2500
FPS supports 2560x2048 and Raptor 2100 FPS supports
2048x2048.
4.5

Trzconfig Utility

After installation you can configure the X Window screen
resolution, bit-depth, and refresh rate for your monitor to be
different from the default settings. The trzconfig utility can be
used any time after installation to change these settings. Please
see the man page on trzconfig for a detailed description.
To change the bit-
Refer to Section 4.5 for
4-4

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RAPTOR 1000 - OPENWINDOWS FOR SOLARIS INSTALLATION-REFERENCE and is the answer not in the manual?

Table of Contents