Software Installation For I-Class Cards; Overview; Requirements - Tech Source RAPTOR 1000 - OPENWINDOWS FOR SOLARIS INSTALLATION-REFERENCE Installation And Reference Manual

For solaris
Table of Contents

Advertisement

SOFTWARE INSTALLATION FOR

3.1 Overview

This chapter describes how to install and configure I-Class
Raptor cards. Installation of T -Class Raptor cards is covered in
Chapter 4. The following is a list of I-Class cards:
Raptor 1000
Raptor 2000
Raptor 2500
NOTE: This software must be installed on your system prior to
running OpenWindows on these cards.
The software for the I-Class cards is provided on CD-ROM or by
FTP and is composed of the following packages:
OpenWindows software
TSIrapw
Raptor configuration program
TSIrcfg
32-bit device driver for Raptor 1000 & 2000
TSIrap
cards
64-bit device driver for Raptor 1000 & 2000
TSIrapx
cards
64-bit device driver for Raptor 2500
TSIrapqfpx
32-bit device driver for Raptor 2500
TSIrapqfp

3.2 Requirements

The following are prerequisites for installing the Raptor
OpenWindows for Solaris Software:
The system is running Solaris 2.5.1 or higher.
Chapter 3
I-CLASS CARDS
3-1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RAPTOR 1000 - OPENWINDOWS FOR SOLARIS INSTALLATION-REFERENCE and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents