Installing T-Class Card Driver Software - Tech Source RAPTOR 1000 - OPENWINDOWS FOR SOLARIS INSTALLATION-REFERENCE Installation And Reference Manual

Raptor OpenWindows for Solaris Installation and Reference Manual
At least 2MB of disk space is available in /usr and /.
One or more of the cards listed in Section 4.1 are presently
installed in the system.
4.3 Installing T -Class Card Driver
Software
The following are step-by-step instructions for installing the
Raptor OpenWindows for Solaris Software from a CD-ROM.
1. Install a Raptor card in the computer as described in
Chapter 2.
2. Boot the computer w ith the -r (reconfiguration) option
by performing the following steps:
Power ON the computer.
Wait until you see boot messages displaying on the
screen, then press and hold the Stop (L1) key, and
then press the A key.
At the ok prompt, type boot –r.
3. After the system comes up, log in as root.
4. Insert the CD-ROM labeled "Raptor OpenWindows for
Solaris" into the drive.
5. If
/cdrom/cdrom0
automatically mounted. Change directories to the CD-
ROM by typing the following:
prompt# cd /cdrom/cdrom0/T-Class
exists, the CD-ROM
4-2
was