Table of Contents
Advertisement
SOFTWARE INSTALLATION FOR
4.1
Overview
This Chapter describes how to install and configure T -Class
Raptor cards. Installation of I - Class Raptor cards is covered in
Chapter 3. The following is a list of T-Class cards:
Raptor 2100T
Raptor 1100T
Raptor 2500T
Raptor 2500T-DL
NOTE: This software must be installed on your system prior to
running OpenWindows on these cards.
The software for the T-Class cards is provided on CD-ROM or by
FTP and is composed of the following packages:
Device drivers for the Raptor T-Class cards.
TSItrz.u
OpenWindows DDX for the Raptor T -Class
TSItrzw
cards.
4.2
Requirements
The following are prerequisites for installing the Raptor
OpenWindows for Solaris Software:
The system is running Solaris 2.5.1 or higher.
OpenWindows Version 3.5 or higher has already been
installed on the system. This is typically bundled with the
OS.
Chapter 4
T-CLASS CARDS
4-1
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the RAPTOR 1000 - OPENWINDOWS FOR SOLARIS INSTALLATION-REFERENCE and is the answer not in the manual?