Bowflex Results Series Troubleshooting Manual

3/12/24, 9:12 AM
Results Series BXT6 Treadmill: How do I adjust the incline?
Follow this troubleshooting guide to help resolve incline issues on the Results Series BXT6 Treadmill.
Some common complaints may include:
Incline buttons don't work
Incline doesn't change when adjusted
Incline doesn't adjust the proper amount
Follow these steps to troubleshoot the issue
Tools you may need:
Phillips head screwdriver
6mm hex/Allen wrench or the wrench from the hardware
card included with your machine
1.
Turn your treadmill off and turn it back on. When the display shows the Welcome screen, press one of the preset
Incline buttons on the left side and then press the CONFIRM INCLINE button. Watch to see if the incline motor moves
2.
If it does move, observe and listen to the incline motor. Listen for grinding or clunking noises as the motor moves.
Watch the rails for change in incline as it moves. This may take some time as the incline motor moves slowly. If the
rails do not move or the grinding/clunking noise is present,
3.
If the issue persists, turn your treadmill off and turn it back on. Recalibrate the MCB following this guide:
Results Series Treadmill - Calibrate
4.
If the incline motor doesn't move, do an input/output cable test following this guide:
Treadmill - MCB Communications Test (I/O Cable
I/O Cables [12240.C].
5.
If the communication test passes, check all cable connections from the motor control board (MCB) to the incline
motor. Refer to the "Replace the Incline Motor Assembly" section of the
the MCB and checking the connections. Disconnect each cable (reference 1) and firmly reconnect them to the
MCB [12240.D].
about:blank
Results Series BXT6 Treadmill:  How do I adjust the incline?
order an Incline
MCB [12240.B]. If this fails, resume troubleshooting at Step 6.
Test). If the communication test fails,
(Reference 1)
Motor [12240.A].
BowFlex Results Series
order Upright and MCB
service manual for instructions on accessing
ID: 12240.1
BowFlex
1/4