Bowflex Results Series Quick Start Manual

3/12/24, 9:42 AM
BowFlex Results Series Ellipticals - Button (Key) Test
"Procedure 3"
Applicable for elliptical models: BXE116, BXE216
Follow these steps to test the buttons on your Results Series Elliptical
1.
From the Welcome (or Power Up) screen, hold down the PAUSE/STOP button and Down arrow button together for
3 seconds to enter Console Setup Mode.
2.
The console will display the TOTAL HOURS screen.
3.
Hold down the PAUSE/STOP button and Down arrow button together for 3 seconds to enter Engineering Mode.
4.
Push the Down arrow button until the console displays ENTR KEY TEST.
5.
Push the Enter button. The console displays BUTTON TEST.
6.
Using the guides below, push the corresponding button in the order provided (references 1 and 2). Continue through
all the buttons.
NOTE: If a failed button is discovered, the console may need to be powered down to exit the button test.
7.
When the button test is complete, the console will display DONE, followed by BUTTON PASS.
8.
Push the PAUSE/STOP button to return to the Welcome screen.
9.
Flip the power switch to OFF.
about:blank
BowFlex Results Series Ellipticals - Button (Key) Test
(Reference 1)
ID: 12713.1
1/4