Table of Contents
Advertisement
Password
Setting a password will protect the computer against unauthorized access. Once a
password is set, the system requires the password when entering to the Setup Utility.
If the Password on boot is enabled, the system will require a password when the
computer is turned on.
If you enter a wrong password three times, the message "System
Disabled" appears. Press the power button to shut down the computer,
and after 10 seconds, press the power button to turn it on again.
Your computer supports two different levels of password security: Supervisor
password and User password. A user password is available to be set with the
supervisor password set. If you share the computer with others we recommend that
you set both the supervisor and the user password, and let others know the user
password only.
Setting Password
If not necessary, do not set the supervisor password or user password. If
you forget the password, you cannot boot the computer.
The user password can change the following items:
• System Time
• System Date
• Resolution Expansion
• Set User Password
• Exit Saving Changes
• Exit Discarding Changes
• Save Changes
1.
In the Security menu of the Setup Utility, select Set Supervisor Password or Set
User Password and press Enter.
2.
Type your password (up to eight letters, figures or the combinations), and press
Enter.
3.
Type the same password again, and press Enter.
4.
Press Enter.
5.
Select Exit menu and confirm Exit Saving Changes is highlighted; then press
Enter.
6.
Confirm Yes is highlighted and press Enter. The system restarts.
5
5-5
Advertisement
Table of Contents
