Table of Contents
Advertisement
Connecting to Network
This section describes how to connect to a WEP enabled access point or WPA-
PSK/TKIP capable access point. (WPA-PSK/TKIP refers to WPA with pre-shared key
(PSK) with Temporal Key Integrity Protocol (TKIP) encryption.) For access points
with user authentication, consult your network administrator.
WPA-PSK is a special mode allowing only devices with a matching
network key to access the WPA-PSK capable access point.
Before connecting to wireless network, confirm the access point which you are using
is powered on and ready to use. (Refer to its manual.)
1.
Confirm the antenna indicator is lit.
2.
Right-click the Wireless Network Connection icon (
cannot find the icon click
4
3.
Click View Available Wireless Networks.
4.
Select a network to be connected from the list and then, click Connect.
5.
Type the correct network key in the fields of Network key and Confirm network
key.
Network keys are generated from ASCII or hexadecimal entries. Refer to the
following table for available letters and digits.
ASCII format
Hexadecimal format
*1
0 to 9, a to z, and A to Z (The uppercase and lowercase letters are
distinguished.)
*2
0 to 9, a to f, and A to F (The uppercase and lowercase letters are not
distinguished.)
When you select a network that is not configured for encryption settings,
the caution message appears. Read the message carefully. Although you
can connect to the network by clicking Connect Anyway, security is not
ensured. Select a security configured network.
6.
Click Connect.
4-16
to show all kinds of icons.
WEP Access Point
*1
5 or 13 characters
*2
10 or 26 digits
) on the taskbar. If you
WPA-PSK/TKIP or
AES Access Point
8 to 63 characters
64 digits
Advertisement
Table of Contents
