Table of Contents
Advertisement
8. NO WAIVER. Any failure by either party to this agreement to enforce a specific part of the agreement in
a specific situation is not a waiver of rights under the agreement. The party may still enforce the rest of the
agreement in that situation and may still enforce some or all of the agreement in other situations.
9. This License Agreement constitutes the entire agreement between you and PowerQuest pertaining to its
subject matter. This License Agreement is governed by the laws of the State of Utah. Any litigation arising
from this license will be pursued only in the state or federal courts located in the State of Utah.
Copyright 1994-2004, PowerQuest Corporation. All rights reserved. U.S. Patents 5,675,769; 5,706,472; and
5,930,831; other patents pending in the U.S.A. and elsewhere. PowerQuest is a registered trademark and
EasyRestore is a trademark of PowerQuest Corporation.
Recovery Process
You can format the hard disk and re-install the preinstalled software and set the status
of the computer to the same configuration as you used for the first time. There are two
ways to recover the hard disk drive(s) of the computer: via hard disk and via recovery
CD. The former saves your time, while the latter secures the re-installation data from
potential loss or corruption. The later sections describe the specific steps for each way.
Before you recover via recovery CD, you need to write the recovery data
already installed on the computer onto blank CD-R discs. (Refer to the
later section.) You are allowed to create the recovery CD only once.
Preparation for Re-installation
The following items are necessary for re-installation.
Via Hard Disk
•
Operation Manual
Via Recovery CD
When you recover first time:
•
Operation Manual
•
Five blank 650MB or 700MB CD-R discs for creating recovery CD
A-15
Advertisement
Table of Contents
