HOMCOM 821-024V70 Instruction Manual page 8

Control panel operation
7. 'Air clean' button
This appliance has a built-in negative anion and UVC. Press this button to enter the air
circulation mode, which cleans the air only. Press the fan speed button to adjust the speed.
Ionic and UCV function
When the appliance is running, the ionic an UVC lamp works automatically.
8. Auto-swing button
Press this button and the corresponding indicator will light up. The louvre will start to swing
automatically.
9. Sleep button
When the appliance is running in any mode, press this button to activate the sleep function. All
lights except the 'sleep', 'water full' and 'child lock' lights will be off. Press any key in sleep
mode to wake the appliance up.
10. Child lock
Press the 'auto-swing' and 'air clean' buttons simultaneously to activate and deactivate the child
lock function. When entering this function, the LED will display 'LC' and flash for five seconds,
then resume its normal display.
During this function, you cannot operate the appliance. If you press other buttons, the LED will
display 'LC' and flash for five seconds, reminding you that the appliance is locked. You can still
turn the appliance off during this function.
11. Defrost function
When the evaporator coils become frosted, the defrost indicator will illuminate, meaning the
defrost function will start. The compressor will switch off and the fan will run until the frost is
removed. When the unit runs at a room temperature between 5-12ºC, it will stop and defrost
approximately every eight minutes. When the room temperature is between 12-18ºC, it will stop
and defrost approximately every 25 minutes.
When the room temperature is between 18-24ºC, it will stop and defrost approximately every
120 minutes. Wait three minutes before resuming operation. After the compressor has stopped,
it will not restart until three minutes have passed.
"Water tank full' indicator"
When the tank is full, this indicator will show on the display and the buzzer will sound 20 times.
The compressor will turn off and the fan will automatically stop after several minutes.
NOTE: If the tank is removed or not placed properly, the full indicator will show.
Auto restart
If the unit unexpectedly turns off due to a power cut, it will automatically restart to the previous
function when power resumes. If the timer is set before the power failure, the auto restart
function will be deactivated.
8