Table of Contents
Advertisement
5. Specifies the location where the step is to be inserted.
Use PAGE/CURSOR [
]/[
VALUE [-]/[+] to specify the value.
fig.r09-12_40
Value
Step:
Specifies the location from which the step is to be
inserted.
for:
Specify the number of steps to be inserted.
6. Press PAGE/CURSOR [
VALUE [-]/[+] to select the pattern to be inserted.
fig.r09-13_40
7. When you are finished editing each parameter, press
[ENTER] to finalize the values.
Copying a song (SONG COPY)
This operation copies a song to a specified location in the current
song. This can be used to combine two songs into a single song, or to
combine parts of various songs to create a different song.
* If there is already data in the current song, the song data of the current
song will be rewritten. The number of patterns in the current song may
increase, such as when the copy-source song contains more patterns
than the current song.
1. Press [SONG] so it is lit and you are in Song mode.
2. Press [UTILITY].
3. Use PAGE/CURSOR [
]/[
fig.r09-14_40
4. Press [ENTER].
5. Use VALUE [-]/[+] to select the copy-source song.
fig.r09-15_40
Value:
01–99
6. Press PAGE/CURSOR [
Use VALUE [-]/[+] to specify the range of steps that you want to
copy.
fig.r09-16_40
Value
Step:
Specifies the step at which copying is to begin.
for:
Specifies the number of steps to be copied. If you
select "ALL," all steps from what you specified for
Step to the last measure of the song will be copied.
Connecting patterns to create a song (Song mode)
] to move the cursor, and use
] to move the page and use
] to select "3:SONG COPY."
].
7. Press PAGE/CURSOR [
Use VALUE [-]/[+] to specify the copy-destination step of the
current song.
fig.r09-17_40
Value: 01– max. 50
8. Press PAGE/CURSOR [
Use VALUE [-]/[+] to specify the copy mode.
fig.r09-18_40
Value
The data will be inserted into the current song.
INSERT:
REPLACE: Data in the current song will be erased (i.e.,
overwritten) when the copy takes place.
9. Press PAGE/CURSOR [
Use VALUE [-]/[+] to set the number of times that the song is to
be copied.
fig.r09-19_40
Value: 1– max. 50
10.When you are finished editing each parameter, press
[ENTER] to finalize the values.
Initializing the parameters of a
song (SONG INIT)
This operation initializes the current song.
1. Press [SONG] so it is lit and you are in Song mode.
2. Press [UTILITY].
3. Use PAGE/CURSOR [
]/[
fig.r09-20_40
4. Press [ENTER].
fig.r09-21_40
5. Press [ENTER] again to execute.
After the initialization has been carried out, the display will indicate
"COMPLETED."
].
].
].
] to select "4:SONG INIT."
117
Advertisement
Table of Contents
