Copying A Patch(Copy) - Roland Octapad SPD-20X Owner's Manual

Copying a Patch(COPY)

This operation copies Patch settings to another Patch. If you need another Patch that is only slightly
different from an existing one, copy that Patch and then make the changes that you need.
When you execute COPY, the contents of the copy destination patch are rewritten.
MEMO
1
If you want to copy the patch currently editing to another patch. Press [EDIT] to save your current patch
NOTE
first and then press [EDIT] again to enter Edit mode and start copying.
2
3
The copy source Patch can be selected from user Patches (U01–U99) or factory preset Patches (P01–P99).
4
When you execute COPY, the destination patch data will be overwritten.
NOTE
You may strike the pad to listen to the instruments when selecting.
MEMO
Play the pads to check the selected Patch.
To quit without copying, press [COPY] or [EDIT].
5
6
7
Copy source
Patch
User Patch U1– U99
Preset Patch P1– P99
Press [EDIT] to enter the Edit mode.
Press [COPY].
Use PATCH/VALUE [-] or [+] to select the copy source Patch.
COPY: SOURCE
01:Drums&shaker
Press [ ] or [ ] to go to destination selection. Use PATCH/VALUE [-] or
[+] to select the copy destination Patch.
COPY: Dest
02:Latin Set
Press [ALL/ENTER]. The following confirmation screen will be shown:
COPY
COPY OK? YES
Use PATCH/VALUE [-] or [+] to toggle between 'Yes' and 'No' , then press
[ALL/ENTER] to confirm
Press [EDIT] once again to return to the Play mode.
Copy destination
Patch
User Patch U1– U99
2
37