Roland RS-70 Owner's Manual page 111

45: AUTO PAN
The Auto Pan effect cyclically modulates the stereo location of the
sound.
fig.MFX-45
L in
Auto Pan 2-Band EQ
R in
Auto Pan 2-Band EQ
Parameter Value
Mod Wave TRI, SQR, SIN,
SAW1/ 2
SAW1
Rate # 0.05–10.00 [Hz],
note *2
Depth # 0–127
Reset OFF, ON
LEVEL
Low Gain -15– +15 [dB]
High Gain -15– +15 [dB]
Level 0–127
46:TUMBLING DLY (Tumbling Delay)
This is a delay that first produces "tumbling" delayed repeats, and
then echoes the original sound.
It is most effective when applied to single notes of a "one-shot"
sound.
fig.MFX-46
L in
Balance D
Tumbling Delay
Feedback
R in
Balance D
L out
R out
Description
TRI: The sound will be modulat-
ed like a triangle wave.
SQR: The sound will be modu-
lated like a square wave.
SIN: The sound will be modulat-
ed like a sine wave.
SAW1/2: The sound will be
modulated like a sawtooth
wave. The teeth in SAW1 and
SAW2 point at opposite direc-
tions.
SAW2
Adjusts the frequency (speed) of
the change.
Sets the depth to which the ef-
fect is applied.
This setting determines whether
the period for the pattern is reset
(ON), or not (OFF) when sounds
are played.
While the sequencer is playing,
the period for the pattern is not
reset even if you set this ON.
RESET
Adjusts the gain of the low fre-
quency.
Adjusts the gain of the high fre-
quency.
Adjusts the output level.
2-Band
L out
EQ
Balance W
Balance W
2-Band
R out
EQ
Parameter Value
Type TYPE1–TYPE6
Pre Delay 0–500 [ms]
Delay Time 0–345 [ms]
Level
original tone
A
HF Damp 200–8000 [Hz],
BYPASS
Feedback # -98– +98 [%]
Balance # D100:0W–
D0:100W
Level 0–127
47: FBK RIPPER (Feedback Ripper)
This effect repeatedly cuts the sound, and outputs a delayed sound
for the cut portion. You can create new phrases by applying this to a
drum phrase or other phrase.
fig.MFX-47
L in
Delay
Feedback
Feedback
Delay
R in
Adding effects
Description
Selects one of the six available
types for the number of delay
sounds heard in time "A" in the
diagram below.
Adjusts time "A" in the diagram
below.
Adjusts time "B" in the diagram
below.
B B
Adjusts the frequency above
which sound fed back to the ef-
fect will be cut.
If you do not want to cut the
high frequencies of the feed-
back, set this parameter to BY-
PASS.
Adjusts the proportion (%) of
the delay sound that is fed back
into the effect.
Negative (-) settings will invert
the phase.
Adjusts the volume balance be-
tween the direct sound and the
delay sound.
With a setting of D100:0W only
the direct sound will be output,
and with a setting of D0:100W
only the delay sound will be out-
put.
Adjusts the output level.
2-Band
Ripper L out
EQ
2-Band
Ripper
R out
EQ
111