Table of Contents
Advertisement
Using the sequencer to create patterns (Pattern mode)
Transmitting pattern settings from
the MIDI OUT connector (XFER to
MIDI)
You can transmit the settings of the current pattern or user pattern
from the MIDI OUT connector. This function lets you save pattern
settings on an external sequencer.
fig.r06-76ai
What
Selects the data to be output.
The data transmitted to the external device is only the portion
other than the music data of the pattern. If you want to save all
of the pattern data including the music data, use the RS-70's disk
drive to save the data on a floppy disk.
Transmitting the settings of currently
selected pattern
This operation lets you transmit the settings of the current (edited
and unsaved) pattern.
1. Choose "CUR PTN/PERF."
fig.r06-76_40
2. Press [ENTER].
The selected pattern settings will be transmitted from the MIDI
OUT connector.
When the display indicates "COMPLETED," the transmission has
been completed.
Transmitting the settings of a user
pattern
1. Choose "USER PTN/PERF."
fig.r06-77_40
2. Press PAGE/CURSOR [
Specify the range of patterns whose settings you want to
transmit.
Use VALUE [-]/[+] to specify the first pattern of the range of
patterns you want to transmit.
fig.r06-78_40
90
].
3. Press PAGE/CURSOR [
Use VALUE [-]/[+] to specify the last pattern of the range of
patterns you want to transmit.
fig.r06-79_40
4. Press [ENTER].
The pattern settings of the specified range will be transmitted
from the MIDI OUT connector.
When the display indicates "COMPLETED," the transmission has
been completed.
Restoring the factory settings
(FACTORY RESET)
You can also perform the FACTORY RESET operation from Pattern
Utility.
fig.r06-80i
For more about FACTORY RESET, refer to "Reset to default
factory settings (Factory Reset)" (p. 20).
].
Advertisement
Table of Contents
