Table of Contents
Advertisement
Performing with an external MIDI device
Filter
You can specify for each clip whether it will be switched. If you set
this to "OFF" for a certain clip, that clip will not be selected even if
you press the corresponding key.
Value
Clip01–Clip32
OFF, ON
Speed Range
Specifies the amount by which the image playback speed can change
when you operate the pitch bend lever. A value of "1" is normal
speed playback. At "0," playback will stop.
Value
0–1–2
0–1–32
0.5–1–2
0.5–1–32
0–1–4
0–2–4
0.5–1–4
0–4–8
0–1–8
0–8–16
0.5–1–8
0–16–32
0–1–16
(-2)–1–4
0.5–1–16
(-6)–1–8
Ctrl Tx Ch (V-LINK Controller Transmit
Channel)
When you operate a controller (knob/modulation lever) to switch
images, this setting specifies the channel whose controllers you can
operate to switch images. If you select "CURRENT," the channel
setting will change according to the Current Part setting.
Value:
CURRENT, 1–16
Exceptionally, Dissolve Time will change according to the Clip
Tx Ch (V-LINK Clip Transmit Channel).
C1–C3
CUTOFF
RESO (Resonance)
MOD (Modulation)
These settings specify what will be controlled by each of the above
controllers.
Value
OFF:
No function assigned.
DISSOLVE TIME: Controls the Dissolve time (time over which the
image switches).
COLOR CB:
Controls the color-difference signal.
COLOR CR:
Controls the color-difference signal.
BRIGHTNESS:
Controls the brightness.
VFX 1:
Controls Visual effects 1.
VFX 2:
Controls Visual effects 2.
Controls Visual effects 3.
VFX 3:
VFX 4:
Controls Visual effects 4.
OUTPUT FADE:
Controls Output Fade.
* VFX2, 3, and 4 are not supported on the DV-7.
138
Resetting the image (All Reset)
The effect applied to the image will be reset, and brightness, color
difference, etc., will all return to the default value.
1. Press [V-LINK] while holding down [SHIFT].
The RS-70 does not support the Edirol DV-7PR's dual stream
mode.
Advertisement
Table of Contents
