Ricoh Aficio SP C320DN Hardware Manual page 205

Cannot connect with DHCP server.(101/201)
Cannot obtain IP address from DHCP server. Consult your network administrator.
Cannot connect with NetWare print server. (107/207)
Connection with NetWare print server is unavailable.
Cannot connect with NetWare server.(106/206)
Connection with NetWare server is unavailable. Consult your network administrator.
Cannot print.
Check the file you want to print is a supported file type. Check for misfeeds and ask your network
administrator for help.
Check network settings.(103/203)
The IP address setting is incorrect. Check the IP address, subnet mask, and gateway address. For details,
see p.79 "Ethernet Configuration".
Classification Code Error
A classification code is not specified for the print job. Enter a classification code using the printer properties
and print the document again.
For details, see "Registering Classification Codes", Software Guide.
Connect failed:WirelessCard Turn power off, check card.
Check there is a Wireless LAN board installed.
Check that it is a supported board. If it is, check it is installed correctly.
Install the correct board properly. For details, see p.57 "Installing the Interface Units".
Cover Open. Please close the indicated cover.
Close the cover indicated on the control panel.
Duplex mode is in off position for (tray name)
The duplex mode for the indicated tray is off; you can only use one-sided printing. Press [Change] to change
the tray's settings, press [JobReset] to reset the job, or press [Form Feed] to force printing.
ECO Night Sensor did not turn Power Switch off. Turn switch off manually or to use, press any
key.
Auto power off by the [ECO Night Sensor] function failed. Turn off the power manually, or press any key
to use [ECO Night Sensor] auto power off function.
Ethernet Board Error
An error on the Ethernet board is detected. Pull out and then re-install the controller board. If the problem
persists, contact your sales or service representative.
Error and Status Messages Appear on the Control Panel
9
203