Envelopes - Ricoh Aficio SP C320DN Hardware Manual

6. Loading Paper

Envelopes

Paper type setting using the
control panel
Paper type setting using the
printer driver
Supported input tray
Duplex printing
6
Note
• To load envelopes that open along the long edge, set the flap edge against the left paper guide. If
the flap of the envelope is folded closed, set the flap edge flush against the left paper guide. If the
flap of the envelope is open, set the envelope with the tip of the open flap against the left paper guide.
114
The [Menu] key > [Paper Input] > [Paper Type: Bypass Tray] >
[Envelope] > the [OK] key
[Envelope]
This paper type can be printed only from the bypass tray.
Not supported
• Check there is no air in the envelopes before loading.
• Load only one size and type of envelope at a time.
• Some kinds of envelope might cause misfeeds, wrinkles or print
poorly.
• Print quality on envelopes may be uneven if parts of an envelope
have differing thicknesses. Print one or two envelopes to check
print quality.
• In a hot and humid environment, the envelope might be output
creased or improper printing quality.
• The number of envelopes that can be printed in one minute is
approximately half that of Plain Paper 1.
• Paper can be loaded only up to the lower of the two paper limit
marks of the bypass tray.
• If printed envelopes come out badly creased, load the
envelopes in the opposite direction. Also, configure the printer
driver to rotate the print object 180 degrees.
• Environmental factors can degrade the print quality on both
recommend and non-recommended envelopes.
• After printing, envelopes sometimes have creases along their
long edges and toner smear on their unprinted sides. Their print
images might also be blurred. When printing large, black-solid
areas, striping can occur as a result of the envelopes
overlapping.