Install The Cradle And Mount - Rand McNally Intelliroute TND-510 User Manual

Rand McNally IntelliRoute ® TND TM 510 User's Guide

Install the Cradle and Mount

Select an area with a line of sight to the sky and GPS satellites to ensure reliable
GPS information.
Note: Obey all local regulations governing the placement of the mount.
Note: Do not place the mount in an airbag deployment area.
1. Clean and dry the mounting area.
2. Remove the suction cup protective fi lm.
3. Adjust the angle of the mount using the thumbscrew and slide the mount
onto the cradle.
4. Pull the suction cup lever up to release suction.
5. Place and hold the mount suction cup against the mounting surface.
6. Press the suction cup lever down until it snaps into place.
7. Angle the bottom of the device into the cradle and align the two slots on the
bottom of the device into the two projections on the cradle.
8. Press the top of the device towards the cradle until you hear the upper clip
latch into place.
9. Plug the power cord into the device and the vehicle's 12 volt power source.
10. Adjust the navigation device so that it can be easily seen and does not block
the driver's line of sight.
Version 2.0.1 10