Table of Contents
Advertisement
Install the Mount
NOTe:
Follow all local regulations governing the placement of the mount.
Select an area with a line of sight to the sky and GPS satellites to ensure reliable GPS information.
1
Clean and dry the mounting area.
2
Remove the suction cup protective film.
Adjust the angle and secure the cradle to the mount using the thumbscrew.
3
Pull the suction cup lever up to release suction.
4
Place and hold the mount suction cup against the mounting surface.
5
Press the suction cup lever down until it snaps into place.
6
Angle the bottom of the device into the cradle and press the top of the device towards the cradle until you hear the upper clip latch into place.
7
8
Plug the power cord into the device and the vehicle's 12-volt power source.
9
Adjust the navigation device so that it can be easily seen and does not block the driver's line of sight.
6
For Sales Information Please Contact RoadTrucker Inc (www.RoadTrucker.com)
8312 Sidbury Rd.; Wilmington, NC 28411 - (800) 507-0482 / (910) 686-4281
Advertisement
Table of Contents
