Install The Cradle And Mount - Rand McNally TripMaker RVND 5510 User Manual

Rand McNally TripMaker RVND
®

Install the Cradle and Mount

Select an area with a line of sight to the sky and GPS satellites to ensure
reliable GPS information.
Note: Obey all local regulations governing the placement of the mount.
Note: Do not place the mount in an airbag deployment area.
1. Clean and dry the mounting area.
2. Remove the suction cup protective film.
3. Adjust the angle of the mount using the thumbscrew and slide the mount
4. Pull the suction cup lever up to release suction.
5. Place and hold the mount suction cup against the mounting surface.
6. Press the suction cup lever down until it snaps into place.
7. Angle the bottom of the device into the cradle and align the two slots on
8. Press the top of the device towards the cradle until you hear the upper clip
9. Plug the power cord into the device and the vehicle's 12 volt power
10. Adjust the navigation device so that it can be easily seen and does not
User's Guide
TM
onto the cradle.
the bottom of the device into the two projections on the cradle.
latch into place.
source.
block the driver's line of sight.
Version 1.04 11