Install The Mount - Rand McNally TruckGPS TND 525 Quick Start Manual

Install the Mount

NOTE: Follow all local regulations governing the placement of the mount. Select an area with a line of sight to the
sky and GPS satellites to ensure reliable GPS information.
1. Clean and dry the mounting area.
2. Remove the suction cup protective fi lm.
3. Adjust the angle of the mount using the
thumbscrew.
4. Pull the suction cup lever up to release
suction.
5. Plug the power cord into the device and
the vehicle's 12-volt power source.
6. Slide the device onto the mount.
7. Place and hold the mount suction cup against the
mounting surface.
8. Press the suction cup lever down until it snaps into place.
9. Adjust the device so that it can be easily seen and does not block the driver's line of sight.
2