Advertisement
Install the Mount
NOTE: Follow all local regulations governing the placement
of the mount.
1. Select an area with a line of sight to the sky and
GPS satellites.
2. Clean and dry the mounting area.
3. Remove the suction cup protective film.
4. Adjust the angle of the mount using the thumb screws.
5. Pull the suction cup lever up to release suction.
6. Plug the power cord into the device and the vehicle's
12-volt power source.
7. Optional: To use your vehicle's speakers, connect an
AUX cable from the device's AUX out to your vehicle's
AUX in port.
8. Slide the device onto the mount.
9. Place and hold the mount suction cup against the
mounting surface.
10. Press the suction cup lever down until it snaps into place.
11. Adjust the device so that it can be easily seen and does
not block the driver 's line of sight.
4
TND
550 Quick Start Guide
™
Advertisement
